3D Print the Metronome Stand

Save Subscribe
circuitpython_metronome-2118.jpg

Download the .stl files and print the parts using PLE at 0.2mm layer height, no support needed.

The bottom cover won't be necessary.

Assembly

Place the CLUE into the case back and then snap-fit the front cover into place.

Push the CLUE in its case into the stand face until the front plate is just proud of the surface.

You can optionally add a bead of CA glue along the back edges for a more secure fit.

To prevent sliding, adhere three rubber bumper feet to the underside of the base.

Set the face plate and CLUE into the base as shown.

circuitpython_metronome-2126.jpg
 Code the Metronome

This guide was first published on May 09, 2020. It was last updated on May 09, 2020.

This page (3D Print the Metronome Stand) was last updated on May 08, 2020.

Text editor powered by tinymce.