Your MEMENTO camera comes unassembled. Make sure you have all the pieces needed to assemble your camera.
Assemble MEMENTO per the guide page below.
If you see the MEMENTO powered on at this point (the screen is on), slide the switch marked ➡On to the left, towards the upper left corner of the camera. The display should go dark and the green LED next to the switch should not be lit.
With the MEMENTO powered off, take a microSD card with the non-straight edge to the right and printing on top (gold contacts on the bottom), insert the card into the slot where microSD is printed on the back of the camera.
It is below the connector used to provide power and signal to the lights on the front of the camera (if installed). On the rear of the camera its labeled microSD. It's a small slot so it may be a bit hard to see at first.
See the orientation of the card in relation to the slot.
Orient the micro SD card as shown and press it into the SD card reader slot -- you'll press it all the way in until it clicks and stops and then as you let off the pressure it'll click a second time.
If it seems to not seat, remove the card and try again.
With your MEMENTO fully assembled, look on the top left from the rear of the camera. There is a slide switch marked ➡On. Using your fingernail, slide the switch towards the right.
When you want to turn the camera off, slide the same switch towards the left and watch for the display to power off.
When the camera is off, it is safe to remove the microSD card by pressing on the edge, waiting for it to disengage, then gently pulling it out.
Text editor powered by tinymce.
