To ensure proper cable connection, it is recommended first to lay out the cables and check their orientation using the arrow markings present on each matrix. The arrows on both matrices should be pointing upward and to the right.
Place the second matrix to the right of the first Matrix. Next, plug an IDC cable into the first Matrix's right port and the second Matrix's left port.
Connecting Matrices
To mount the DIN rails securely, carefully position them to center them over the top and bottom threaded inserts.
Once it is properly aligned, the magnet holder screws to the threaded inserts. This will ensure that the DIN rail stays firmly in place.
Power Terminals
Next, screw in the spade connectors to the corresponding standoff.
- red wire goes to +5V
- black wire goes to GND
Panel Power
To supply power to each panel, you'll need to connect a power plug to the power connector pins. It's important to note that the plug can only be inserted one way, and this way is indicated on the board's silkscreen.
Look for the markings on the board and align the plug accordingly to ensure that it is installed correctly.
Text editor powered by tinymce.
