This project will be assembled with quite a few 3D printed parts, described below, but many of them are duplicates. The parts are available in either the STL (older) or 3MF (newer) format. Most slicers support both. You'll need to print multiples of some parts:
- 6 x Connector Bracket.stl
- 7 x Top or Bottom Panel.stl
- 1 x Top Panel with Cutout.stl
- 2 x Side Panel.stl
- 1 x MatrixPortal Mount.stl
Slicer Settings
The specific setting values aren't critical with this case. Here are the settings used to print the case for this guide.
For the Connector Bracket and MatrixPortal Mount:
- 20% gyroid infill
- Supports on build plate enabled
- 0.3mm Layer Height
For the other parts:
- 20% gyroid infill
- 0.2mm Layer Height
- No Supports
Connector Bracket
Used to connect the matrices together, has a dovetail for the panels, and a zip tie slot.
Side Panel
Panel for each side of the message board. These attach to the matrix, but also slot into the Top and Bottom Panels.
Text editor powered by tinymce.
