Align Handles

Position both handles so they are aligned with the screw mounts on the back of the matrix. 

Use M3 screws or our magnet thumb screws to secure the handles to the matrix display.

Plug in Matrix Portal

The HUB75 port press fits into data in port on the back of the matrix.

 

Power Cables

The included power cables attach to the power and ground screw mounts with the included screws. 

The female side of the power cable plugs into the VCC and GND pins.

Attach USB cable

A USB C cable plugs into the USB port on the Matrix Portal. 

Use a right angled USB cable or right angle extender to keep the wiring minimal.

Use a USB battery pack like our small 2200 mAh USB Battery Pack.

Attach Acrylic 

Our Black LED acrylic softens up the LEDs and keeps the colors looking vibrant. 

You can attach acrylic to the display using ProTapes glue dash sheets.

Just attach small pieces to the corners and remove the protective backing.

Then just line up the acrylic with the edges and stick it over the display.

This makes the display show up much better on camera so you can have it in the background of your video calls.

This guide was first published on Sep 23, 2020. It was last updated on Mar 08, 2024.

This page (Assembly) was last updated on Mar 08, 2024.

Text editor powered by tinymce.