Amp Gain
Bridge the 12db pad and center pads with a bit of solder to increase the amplifier volume.
Solder Slide Switch
Measure a short wire and solder the two pins on the slide switch to EN and GND pins on the Feather.
Speaker Extension
Use a JST 2 pin socket extension to connect the speaker. Attach to the + and - to the terminal blocks.
Button Wires
Attach wires to the 5V, GND and Button terminal blocks.
Feather mount
Align the pins on the feather mount to the screw holes next to the terminals. Use M2.5x5mm screws on the other two screw holes.
Attach Feather to Base
Use two M2.5x6mm screws to attach the Feather mount to the base part.
NeoPixel Ring Wires
Measure and cut wires to connect the Data Input, 5V and GND to the 24 NeoPixel ring.
Mount NeoPixel Ring
Align the ring to the mount on the base part. Pass wires through the cut out on the base. Connect NeoPixel wires by sharing the 5v and GND terminal.
Mount Servo
Align the servo wire to the cutout on the base part. Pass the cable through the cutout on the base and connect to the header pins on the Feather.
Mount Battery
Orient the battery with the cable facing up.
Speaker Mount
Use M2.5x6mm screws to secure the speaker mount to the base part.
Attach Speaker
Press fit the speaker base into the mount.
Battery JST extension cable
Connect an 2 pin JST extension cable to the battery.
Pass Button wires
Align the USB port to the cutout on the handle part. Pass button wires through the cutout.
Share Button Ground connection
Solder an additional button connector to the ground wire.
Connect Button wires
Attach the wires to each pin on the button.
Speaker and Battery Connections
Secure cables for the speaker and battery to the ports on the Feather.
Align base to handle
Coil wires around the speaker to fit in the handle.
Align the USB port to the cut out on the handle part.
Use M2.5x6mm screws to attach the base to the handle.
Page last edited March 08, 2024
Text editor powered by tinymce.
