Grab a NeoPixel stick and consult the Adafruit NeoPixel Überguide for hook-up details o' plenty.
Insert the stick into the mouth hole...
This isn't a snap-fit, so you're going to have to secure it with something.
I used a bit ot painters tape on the back and then added a bit of hot-glue on the front to hold it in place.

Connect the Neo Pixel stick as follows:
  • VCC --> 3v
  • GND --> GND
  • SIG --> D7 (digital pin)

This guide was first published on Feb 17, 2014. It was last updated on Oct 19, 2013.

This page (Mouth) was last updated on Oct 19, 2013.

Text editor powered by tinymce.