This paper craft Makey is perfect for setting up at your maker faire booth or any event! we can make this completely out of card stock or card board! Connect a micro servo to enable waving action to greet an audience!

The Circuit Playground Express drives the micro servo and is activated by two on board push buttons. Or use MakeCode to activate with one of the many sensors on board like light, sound, temperature and even motion!

1 x M2x6mm Screws
M2x6mm Screws
1 x M3 x 6mm Screws
M3 x 6mm Screws
4 x M3 brass male-female standoff(5mm + 6mm)
M3 brass male-female standoff(5mm + 6mm)
1 x Chipboard Medium Weight
12x12inch 25qt pack – 30pt (624gsm / 0.8mm)
A Black woman's manicured hand holds a round microcontroller with lit up LEDs.
Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
$24.95
In Stock
 Bundle of Small Alligator Clip to Male Jumper Wires
For bread-boarding with unusual non-header-friendly surfaces, these cables will be your best friends! No longer will you have long strands of alligator clips that are grabbing little...
Out of Stock
Micro servo with three pin cable
Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo...
$5.95
In Stock
Front angled shot of 3 x AAA battery holder with on-off switch and 2-pin JST PH connector.
This battery holder connects 3 AAA batteries together in series for powering all kinds of projects. We spec'd these out because the box is slim, and 3 AAA's add up to about...
$1.95
In Stock

This guide was first published on May 19, 2018. It was last updated on May 19, 2018.

This page (Overview) was last updated on Aug 05, 2022.

Text editor powered by tinymce.