Install Buttons

Hold the top half of the enclosure face side down and place the four buttons into the holes. Then set it aside.

Install Battery (Optional)

Connect the optional 500mAh lipo battery to the MagTag. Use a piece of double-sided tap or mounting tack to keep the battery adhered to the MagTag's PCB.

Install MagTag

Get the bottom half of the enclosure and four M3 x 6mm long nylon screws.

Orient the MagTag with the bottom half of the enclosure. Place the MagTag into the bottom with the mounting holes lined up.

Secure MagTag

Flip the MagTag and bottom part and fasten the M3 screws into the four mounting holes.

Install Switch

Place the switch into the slot near the MagTag's on/off switch. The actuator of the on/off switch should fit in between the two nubs.

Join Top and Bottom

Orient the top and bottom half of the enclosure parts so they orient. While holding the switch in place, begin joining the two halves together making sure the four buttons stay in place.

Firmly join the two halves together until they snap fit closed.

Kickstand

To use the kickstand, locate the notch on the back side. To pop out the stand, fit your fingernail under the ridge of the stand and pull it out.

The stand can be stowed away by snaping it into the back side of the enclosure.

Assembled Case

The assembled case is ready to prop on your desk, or stick to your refrigerator or other metal surface using the magnetic feet.