Snap Fit Case

This case is designed to protect the Adafruit MagTag. It features cutouts for the four user buttons, USB-C, and on/off switch. The reset and DFU side buttons feature reliefs that allow the overlays to actuate the switches. 

You may also use vinyl to create covers with beautifully glossy holographic decals.

Vinyl & Acrylic Upgrade

Have access to a CNC mill, vinyl or laser cutter? Use our SVG files to create custom decals, back and front faceplates. 

Desktop Stand

Want to prop up the MagTag on your desk? This simple 3D printed stand mounts the MagTag at a 70 degree angle for perfect viewing. The wide bottom prevents the stand from tipping over. An hole in the lower center allows a STEMMA cable to pass through for connecting other I2C sensors.

Parts

Angled shot of Adafruit MagTag development board with ESP32-S2 and E-Ink display.
The Adafruit MagTag combines the new ESP32-S2 wireless module and a 2.9" grayscale E-Ink display to make a low-power IoT display that can show data on its screen even when power...
Angled shot of four magnet feet.
Got a glorious RGB Matrix project you want to mount and display in your workspace or home? If you have one of the matrix panels listed below, you'll need a pack of these...
Lithium Ion Polymer Battery 3.7v 420mAh with JST 2-PH connector and short cable
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
USB Type A to Type C Cable - approx 1 meter / 3 ft long
As technology changes and adapts, so does Adafruit. This  USB Type A to Type C cable will help you with the transition to USB C, even if you're still...

This guide was first published on Nov 18, 2020. It was last updated on Mar 08, 2024.

This page (Overview) was last updated on Mar 08, 2024.

Text editor powered by tinymce.