If you like soldering and crafting, this intermediate project is for you. We'll be using a Trinket and a motion sensor, so make sure you review the following guides:
Here's the supplies you'll need:
- Trinket 3.3V
- USB Cable A/Mini B
- JST-PH 2-Pin SMT Right Angle Connector
- LiPoly Battery-3.75V 500mAh
- LED Sequins Warm White - 10 (2 packs)
- PIR Motion Sensor
- Silicone Cover Stranded Wire 30AWG - 2 colors/2 meters each
- Soldering Equipment and Tools
- Dremel tool
- Hot Glue Gun
- Breadboard and wires for testing parts (helpful)
- Mistletoe Bunch (I used the one on Afloral.com)
- Green Felt (Approx. 5" square)
- White Wide Satin Ribbon - Approx. 1 yd.
- Floral Tape (available in craft stores)
- Scissors
- Needle and Thread
![Debug Header for the Feather [M0]](https://cdn-learn.adafruit.com/guides/cropped_images/000/001/563/medium640/m0-debug-1.JPG?1520544696)
