You can build your own Disney magic band scanner with Adafruit Feather RP2040 and CircuitPython.
This project uses the RFID Wiz Kit to scan your Disney magic bands to animate a strip NeoPixels and plays your favorite sound effects.
Prerequisite Guides
Take a moment to review the guides.
RFID made easy! RFID Wiz is the easiest way to include RFID in all your projects. Their ONE-TOUCH training system will have you...
$49.95
In Stock
Fancy new side light LED strips are a great alternative for folks who have loved and used Adafruit LED strips for a few years but want gorgeous, glowy light emitting at...
guides with product
Out of Stock
A new chip means a new Feather, and the Raspberry Pi RP2040 is no exception. When we saw this chip we thought "this chip is going to be awesome when we give it the Feather...
guides with product
Out of Stock
Hear the good news! This wee speaker is a great addition to any audio project where you need 8 ohm impedance and 1W or less of power. We particularly like...
$1.95
In Stock
Listen to this good news - we now have an all in one digital audio amp breakout board that works incredibly well with the
guides with product
$5.95
In Stock
For those who are fans of our silicone-covered wires, but are always looking to up their wiring game. We now have Silicone Cover Ribbon cables! These may look...
$3.95
In Stock
Totaling 420 pieces, this M3 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel...
$16.95
In Stock
Hardware Fasteners
The following hardware is required for assembling this project.
- 4x 6mm long M-F hex nylon standoffs
- 4x 10mm long M2.5 nylon screws
- 8x M2.5 nylon hex nuts
- 2x M2.5 x 8mm long nylon screws
- 2x M2.5 nylon hex nuts
- 4x M3 x 4mm long nylon screws
- 4x M3x6mm machine screws
- 2x M3 x 6mm machine screws
- 2x M3 x 10mm machine screws
Page last edited September 25, 2025
Text editor powered by tinymce.
