Create the Mad Science

John Park
projects_ttBT_midLit-1.jpg
projects_ttBT_details-4.jpg

You can now attach the FeatherWing to the vertical support of the laser cut acrylic using the M3 standoffs, screws, and nuts. 

If you're using a different stand, you'll want to attach the Feather using another method, such as drilling small holes in the wood, or affixing with double-stick foam tape.
projects_m3_IMG_7533.jpg

Place a standoff in each of the four holes, then affix a nut to the back side.

projects_m3_IMG_7534.jpg

Place the FeatherWing over the four standoffs and secure with the four screws.

projects_ttBT_details-5.jpg
projects_m3_IMG_7535.jpg

Attach the LED wiring to the screw terminals of the TerminalBlock FeatherWing, using this circuit diagram as reference.

projects_testTubeBreadBoard.png

With a potion-filled test tube in each slot of your rack, push a UV LED into the hole of each stopper and then place the stoppers in the test tubes.

projects_ttBT_details-6.jpg
projects_ttBT_details-3.jpg

Connect the Feather to the wall power adapter using the USB cable, and then plug the adapter into a wall outlet.

Now, turn down the lights, turn the FeatherWing power switch to ON and enjoy the spooky, mad science light show!

projects_ttBT_CU-1.jpg
MIX THE POTIONS
This guide was first published on Oct 17, 2016. It was last updated on Oct 17, 2016. This page (Create the Mad Science) was last updated on Dec 17, 2019.