Boot Loader Mode

Go into boot loader mode to install new firmware on the Fruit Jam. To do this, you'll want to open the back door and follow the sequence.

To enter the bootloader, hold down the BOOT/button #1 (highlighted in red above), and while continuing to hold it (don't let go!), press and release the reset button (highlighted in blue above). Continue to hold the BOOT/button #1 until the RP2350 drive appears!

If the drive does not appear, release all the buttons, and then repeat the process above.

A lot of people end up using charge-only USB cables and it is very frustrating! Make sure you have a USB cable you know is good for data sync.

Connect Power, Mouse and Keyboard

To power the Fruit Jam, use a USB-C cable and connect it to either your computers USB hub or 5V USB power supply.

Connect your preferred keyboard and mouse to the USB-A ports on the Fruit Jam.

Switch On/Off

Use the 3D printed switch to power the Fruit Jam on or off. Slide to the right to power on. Slide left to power off.