Button Wires
Use the 4-pin cable for the RGB LED inside the button.
Create a 2-wire cable using the silicone ribbon cable. Measure and cut to create a wire that is 23cm in length.
Wiring RGB LED
Solder the 4-pin cable to the labeled pins on the button. Follow the RGB LED wiring:
- Red Wire - R Pin (Red LED)
- White Wire - G Pin (Green LED)
- Black Wire - B Pin (Blue LED)
- Yellow Wire - C+ Pin (Voltage)
Slide Switch Wire
Use the silicone ribbon cable to create a 2-pin cable. Measure and cut the wire to be 7.5cm in length.
Wiring Slide Switch
Cut one of the three pins on the slide switch, either the far left or right but not the middle. The, cut the two remaining pins half their length.
Solder the 2-pin cable to the pins on the slide switch.
Wired Slide Switch
Double check the wires have been properly soldered to the pins on the slide switch.
Speaker Wires
Cut the cable from the speaker so the wires are 8cm in length.
Remove a bit of insulation from the two wires and tin them using a bit of solder.
Optionally save the 2-pin connector for another project.
Install Speaker
Peel away the protective backing from the speaker.
Attach the speaker to the bottom of the PCB holder.
Reference the photo for the correct orientation.
Connected Slide Switch
The two wires are soldered to the pins on the bottom of the Feather.
Solder one wire to the ground pin (G) and the other to the enable pin (EN). It doesn't matter which wire goes to which pin.
Text editor powered by tinymce.
