Wiring Speaker

The Prop-Maker FeatherWing features an on-board molex pico blade connector for audio output. The speaker will require a longer wire, so you will need to extend the cable using additional wires.

Suggested Wire Length: 250mm (9.8in)

3d_printing_speaker-wire.jpg

3d_printing_speaker-wire-solder.jpg

3d_printing_speaker-wired.jpg

Molex Pico Blade 2-pin Cable pigtail
When 0.1" is too big, and JST PH's too chunky, the ultra-slim "PicoBlade" is a reliable alternative. These are only 1.25mm pitch, but have a nice clicky...
$0.95
In Stock

This guide was first published on Oct 31, 2018. It was last updated on Mar 28, 2024.

This page (Speaker Wiring) was last updated on Mar 08, 2024.

Text editor powered by tinymce.