First we'll build a super low-profile USB extension cable so we can put our charging / programming port on the bottom of the ukulele, where the strap connector would go. This way we can just plug it in to charge the battery without having to take anything apart.

We'll need a 5-strand ribbon cable. I'm using a multicolored one for clarity. Cut the ribbon cable to around 3-4 inches long.

Make sure you've got all the pieces. You'll need a female connector and snap-fit plastic sheath, 4" of ribbon cable, and your male connector and 2-piece plastic sheath. 

Separate the wires at both ends of your ribbon cable and tin all five wires. Trim just a smidgen off the tips of the wires so they're nice and tidy.

Tin the pads on the female USB connector and solder all five wires to the five pads.

Slip the plastic cover onto the wire and snap it into place around the USB connector.

Plug the male side into the female side for a moment, so you're 100% sure you've got both sides the same way up. 

Once you're sure it's aligned right, tin the pads on the male connector on both sides. Solder the wires as shown - the first, third, and fifth wire go on the the 3-pad side, and the second and fourth go on the 2-pad side. 


Plug your Feather into your computer's USB port via your newly soldered cable. Press the reset button and be sure your Feather shows up as a drive on your computer, in order to be sure the data lines and power lines are all in working order.

Once you're sure your soldering is 100% solid, clip the housing onto the male end of your cable. 

Squeeze a bead of hot glue across the exposed contacts on the female end to keep them nice and secure as well.

This guide was first published on Jul 22, 2020. It was last updated on May 28, 2024.

This page (USB Extension Assembly) was last updated on Mar 08, 2024.

Text editor powered by tinymce.