3D Print the Wand
This bubble wand was designed in Onshape. It prints in 3 pieces: the bubble ring, the handle, and the cap for the end of the handle.
The handle is hollow and will hold the battery and the Mini Sparkle Motion. It attaches to the bubble ring with two small screws. I printed in PETG filament, which is a bit more flexible and water resistant than PLA.
Download the files below.
Slice with settings for PETG material
The parts were sliced using BambuStudio using the slice settings below.
- PETG filament 220c extruder
- 0.2 layer height
- 15% grid infill
- 200mm/s print speed
Bubble Solution Tray
This is a remix from the Bubble Soap Tray Dish by Detail3d on MakerWorld. We've made it a little deeper and appropriately sized for this wand. It's got a convenient pour spout for draining. If you print it from clear PETG it will glow when you dip the wand!
Page last edited July 15, 2026
Text editor powered by tinymce.
