Servos

Just use the mounting screws included with the servo to secure the micro servo to either of the 3D printed mounts.

Feather

The Feather LEGO-compatible mount features a low-profile plate for fitting into tight spaces and allowing wire to run underneath. It's got a series of tubes on the bottom and four built-in stand-offs for securing the board with machine screws.

Use M2.5x6mm screws for the screws near the USB port.

The screws holes near the terminal block require M2x6mm screws.

Slide Switch

A mini slide switch allows one to easily turn the power for builds on and off. To facilitate their use, we designed a little holder that also has LEGO compatible studs.

Move the slide switch toggle to the middle and insert the body at an angle to press fit into place.

DC Servo

Use two Plug to Plug jumper wires to connect the JST port on a battery pack to a DC servo so no microcontroller is required at all!