Servo Assembly

Glue Servo Mount Parts

The servo mount is separated into two pieces in order to 3D print without support material. These two parts need to be glued together.  The bottom surface should be flat and even. Join them together with CA glue and allow time to fully cure and set.

3d_printing_servo-mount-glue.jpg

3d_printing_servo-mount-glueing.jpg

3d_printing_servo-mount-bond.jpg

Install Servo

The body of the micro servo can be inserted into the servo box with the wiring fitting through the slit on the side. The servo box should be able to attached on top of LEGO bricks. Experiment with different placements, gears and mechanisms! PLug in the cable from the servo to one of the available headers in the SERVO section of the CRICKIT board.

This guide was first published on Jul 25, 2018. It was last updated on Jul 25, 2018. This page (Servo Assembly) was last updated on Jan 11, 2020.