Install Anode Wires

Begin inserting the anode wires from the Perma-Proto through the center opening of the bottom mounting plate.

Install Anode Wires Continued

Pull the anode wires through the top mounting plate.

Solder Anode Wires to Noodles

Begin soldering each anode wire to the pins on the LED noodles.

Soldered Anode Wires

Double check all of the anode wires have been properly soldered to the LED noodles.

Solder Ground Wires

Begin soldering each ground wire to the cathode pins on the LED noodles.

Circuit Test

Connect the 3-pin molex cable from the button to the matching cable on Perma-Proto. Then connect the battery to the Lipo Charger BFF. 

Use the on/off switch to power the circuit on. All of the LED noodles should slowly fade on and off.

Double check the built-in switch on the BFF is in the "on" position.