Install LED Noodle to Holders

Begin inserting the end of the noodle through the opening in the holder and pull it through.

Press the silicone filament into the channel of the holder being aware to follow the bend profile. 

Fit the end of the noodle through the second opening and pull it taught. 

Label Ground Ends

Use a permanent marker to label the ground end of the LED noodle. The anode end of the LED features a hole and the cathode (ground) does not.

Install Noodle Holders

Repeat the installation process for all six LED Noodles.

Make sure to mark the ground ends of each holder.

Label Mounting Plates

Use a permanent marker to label the top and bottom mounting plates. A simple letter like "T" and "B" will suffice.

This will help assist in the installation process.

Install Stand Offs

Use two M3 x 8mm long screws to secure the 3D printed standoffs to the top mounting plate.

Install Noodle Holder

Begin installing the holders into the top mounting plate with the label facing away. Insert the end of the holder with no marking.

Start by inserting the tip of the LED noodle through the square holes in the mounting plate.

Install All Holders

Repeat the installation process and install all six holders to the top mounting plate.

Install Bottom Mounting Plate

Begin installing the other end of the holders to the bottom mounting plate.

Secure Bottom Mounting Plate

Use two M3 x 8mm long screws to secure the bottom mounting plate to the 3D printed stand offs.

Secured Holders

Double check the holders have been properly installed with all ends matching.

If using different colored noodles, take a moment to review the arrangement of the holders.

This guide was first published on Oct 05, 2022. It was last updated on Sep 28, 2022.

This page (Noodle Assembly) was last updated on Oct 04, 2022.

Text editor powered by tinymce.