Hardware for Handle

Use the following hardware to secure the handle to the top cover.

• 2x M3 x 10mm long screws
• 2x M3 hex nuts

Secure Handle

Place the handle over the top cover and line up the mounting holes.

Insert and fasten M3 screws through the top of the handle. Install M3 hex nuts to secure the handle to the top cover.

Wiring Button

Measure and cut a piece of 3-wire ribbon cable to about 30cm (11.8in) in length.

Measure and cut a short wire about 3cm in length.

Solder the 3-wire ribbon cable to the pins labeled, COM, NC, LED +.

Solder the short wire to connect pins COM and LED–.

Button Cable

The 3-wire ribbon cable is spliced to the 3-pin molex cable to make a cable with a length of 33cm (13in). 

Install Button

Insert the cable from the button through the center hole in the top cover. Push the button all the way through until it is flush with the top surface.

Secure the button to the cover using the included hex nut. Tighten the hex nut to secure the button in place. 

The length of the button cable is about 33cm (13in ) long.