Clean 3D Print
Use a hobby knife to remove any excess material from the outer edge of the bottom of the 3D print.
Use caution when working with a hobby knife. Eye and hand protection would be prudent.
Installing the LED Noodle
Locate the bottom of the 3D printed LED holder. Begin fitting the two ends of the LED noodle into the channels.
Make sure the two ends of the LED noodle are in a position that is similar to the assembly photo.
Press Fitting LED
Continue to press the LED noodle into the channel, following the zigzag shape.
Repeat the installing for the opposite end of the LED noodle.
Zigzag Loop
A lengthy loop of the LED noodle should be remaining. The remaining noodle will loop over the top of the holder.
Excess Top
Loop the remaining noodle over the top of the holder and start press fitting the remainder into the closest channel.
Repeat the installation for the opposite end of the LED noodle.
Installed LED Noodle
The LED noodle should have enough length to fit through the bottom of the channel.
Double check the entire length of the LED noodle is pressed into the channels.
Test LED Noodle
Connect the positive and negative wires from the LED noodle into the corresponding pins in the HUSB238 breakouts screw-block. Use a screwdriver to secure the connections.
Power the USB breakout using a USB-C cable and the USB PD wall adapter.
Use the slide switch to power the LED noodle.
Coupler & Base
Get the LED coupler and base ready to assemble together.
Use the following hardware to secure the parts together.
- 2x M3 x 6mm long steel machine screws
Install LED Coupler
Press the LED coupler into the bottom of the LED holder so it is fitted into the recess.
Orient the parts so the two mounting tabs are lined up.
Install LED Base
Insert the LED wiring through the top of the LED base. Orient the LED base so the mounting tabs are lined up with the holder and coupler.
Secure LED Base
Use the following hardware to secure the LED parts together.
- 2x M3 x 6mm long steel screws
Fasten the two screws to secure the LED holder, coupler and base.
Text editor powered by tinymce.
