Assemble the Mini Sparkle Motion case

Place the board aligned to the USB C cutout.

Align the terminal cutout on the lid and press fit the edges to snap together.

Mount case

Use M2.5x8mm screws to mount the case to the back leg. Place screws in the center of each tab and fasten to the screw hole on the back leg part.

Attach Back Leg

The tabs on the back leg snap into the existing back leg loops by inserting at an angle. Bending the second tab to press fit into the leg loop.

Drone USB port

The Mirco USB host cable connects to the port on the side of the drone.

Attach front legs

Align the triangular shapes on the legs and insert the drone leg into the printed leg extenders. 

Attach arm clips

Align the trapezoidal clips to the front and back arms with the loops pointed down. Firmly bend the clips back to fit over the arms. 

Prepare LED Net

Use a green metal garden stake to hold the LED net up. 

Cut the stake to 36" inches wide and thread the stake over and under the net at the top (under the square boxes).

Connect the stake to the arm clips with nylon fishing line. 

Measure two 34" inch pieces of line and tie both ends to each side of the stake to create a loop.

Connect line to arms

The nylon lines are inserted into the clips through the cutouts. Pass lines into the loops on the left, back and front arms. Repeat for the right, front and back arms.