Place Lipo Battery


Orient the battery so the wire connections are facing down.


Align Circuit Playground


The battery port aligns with the flaps on the case.

Attach screws


Align the flaps on both parts of the case and fasten four M3x12mm screws to each standoff.

 

Plug in Battery


Pull the lid flaps back to plug in and to disconnect the battery to the Circuit Playground.

To close the port opening, push the larger flap behind the shorter flap.

Charging the Battery

The battery connector can reach out of case and plug into a USB lipo charger to recharge the battery.

Hockey Blade

 

The hockey blade press fits into a 7/8 diameter dowel.

Use an M3 screw to further secure the blade.

This guide was first published on Dec 23, 2020. It was last updated on Dec 23, 2020.

This page (Assemble) was last updated on Dec 22, 2020.

Text editor powered by tinymce.