In this project, we’re making a 3D printed LED hockey puck.

This was inspired by the DIY indoor hockey project by Yuksel Timez.

This hockey puck lights up and makes chips tunes based on motion!

You get a light show each time you hit the hockey puck, so it's still super fun even when you miss a goal.

 

Either the Circuit Playground Express or the Circuit Playground Bluefruit make this a fun and easy project that uses the built-in motion sensor and NeoPixel LEDs.

The case was 3D printed in NinjaFlex filament which lets you use the buttons to switch between different animations.

With MakeCode for the Circuit Playground Express or MakeCode Maker, we were able to quickly make this demo.

MakeCode an easy to use block based code editor that's great if you're just getting started.

Parts

Select either the Circuit Playground Express or the Circuit Playground Bluefruit.

Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
$24.95
In Stock
Circuit Playground Bluefruit is our third board in the Circuit Playground series, another step towards a perfect introduction to electronics and programming. We've...
$24.95
In Stock
Oh so handy, this little lipo charger is so small and easy to use you can keep it on your desk or mount it easily into any project! Simply plug it via any USB C cable into a USB port...
$5.95
In Stock
Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery...
$6.95
In Stock
This cable is not only super-fashionable, with a woven pink and purple Blinka-like pattern, it's also fully reversible! That's right, you will save seconds a day by...
$3.95
In Stock

  

4 x M3 x 12mm
M3-0.50 x 12M
1 x 7/8 Dowel
7/8 Dowel

This guide was first published on Dec 23, 2020. It was last updated on Dec 23, 2020.

This page (Overview) was last updated on Jan 25, 2021.