Installation

Mounting the Circuit playground and Battery is easy.  We'll use use tape to mount the battery, and the Circuit Playground will be held in by the RC Car's cardboard tabs.

Mount the Circuit Playground Express

express_laboRC-4-4x3.jpg

express_laboRC-5a-4x3.jpg

express_laboRC-5b-4x3.jpg

Turn the RC Car upside down and slide the edges of the Circuit Playground Express under two large cardboard tabs. Keep the USB jack pointed toward the car's 'antenna' as seen in the photo above.

Mount the Battery

express_laboRC-6.jpg

express_laboRC-7-4x3.jpg

Apply a small piece of double-sided tape to the battery and press it into place at the front edge of the car's underside.

Connect the battery to the Circuit Playground and turn the car right side up again. That's it - installation is complete :)

This guide was first published on May 02, 2018. It was last updated on 2019-12-04 03:44:26 -0500. This page (Installation) was last updated on Apr 22, 2019.