Rotary encoders are soooo much fun! Twist em this way, then twist them that way. Unlike potentiometers, they go all the way around and often have little detents for tactile feedback. But, if you've ever tried to add encoders to your project you know that they're a real challenge to...

Make your own little LED strip arrangement with this stick of NeoPixel LEDs. We crammed 8 of the tiny 5050 (5mm x 5mm) smart RGB LEDs onto a PCB with mounting holes and a chainable design. Use only one microcontroller pin to control as many as you can chain together! Each LED is addressable as...

This rotary encoder is the best of the best, it's a high-quality 24-pulse encoder, with detents and a nice feel. It is panel mountable for placement in a box, or you can plug it into a breadboard (just cut/bend the two mechanical side tabs.) We also include a nice soft-touch knob with an...

Have you found yourself in a maze of twisty-turny knobs, all alike? These micro potentiometer (or rotary encoder) knobs offer a rainbow burst of color to your synth or control panel. They are made of a hard plastic, with a grippy star shape. The shape is sometimes referred to as...

Have you found yourself in a maze of twisty-turny knobs, all alike? These micro potentiometer (or rotary encoder) knobs offer a rainbow burst of color to your synth or control panel. They are made of a hard plastic, with a grippy star shape. The shape is...

Have you found yourself in a maze of twisty-turny knobs, all alike? These micro potentiometer (or rotary encoder) knobs offer a rainbow burst of color to your synth or control panel. They are made of a hard plastic, with a grippy star shape. The shape is...

Have you found yourself in a maze of twisty-turny knobs, all alike? These micro potentiometer (or rotary encoder) knobs offer a rainbow burst of color to your synth or control panel. They are made of a hard plastic, with a grippy star shape. The shape is sometimes referred to as...

This 4-wire cable is 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead of 2mm, but still have a nice latching feel, while being easy to insert and remove.

This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of 2mm, but still have a nice latching feel, while being easy to insert and remove.

Here is a cute, minimal snap-on mount for your QT Py to keep it safe during use and transport. It has been custom-designed and 3D printed to accommodate the USB-C connector, along with four M3 mounting holes. No screws or glue are...

For those who are fans of our silicone-covered wires but are always looking to up their wiring game. We now have Silicone Cover Ribbon cables! These may look a lot like

Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are our favorite accessory for any electronic kit or device. They are sticky, but not impossible to remove. They're small enough to fit onto any board, and have just enough height to give...

Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M2.5 size screws fit almost all of the Adafruit breakout/dev board mounting holes...