The four LED strips on the top of the jellyfish will all be wired in parallel, with data wire going to pin A0. The two light strips inside the tentacles will be wired in parallel to pin A1.

The power and ground wires from all 6 strips will connect together before connecting to the on/off switch and battery, and from there to the QT Py (power to 5v and ground to G).

With this configuration, all 4 of the top lights will mirror each other, acting as if they're the same strip. The same will happen to the bottom 2 lights. WLED will automatically chain the two data pins, so the animation will run down the top of the umbrella and then continue down the tentacles.