Installing Feather

Get the 3D printed back cover, hardware screws, and Feather ready to assemble.

Place the Feather over the back cover with the mounting holes lined up and the TFT screen facing up.

Use the following hardware to secure the Feather to the back cover.

• 2x M2 x 6mm long machine screws
• 2x M2.5 x 6mm long machine screws

Secure Feather

Install and fasten the hardware screws to secure the Feather ESP32-S2 to the 3D printed back cover.

Ensure the Feather has been secured in the correct orientation.

Connect JST Extension

Plug in the 2-pin JST extension cable to the battery port on-board the Feather ESP32-S2.

Install Case & Battery Tray

Slide the 3D printed case in between the battery tray's two mounting tabs.

Line up the mounting holes, then insert and fasten two M2.5 x 6mm long machine screws to secure the two parts together.

Assemble Enclosure

Orient the back cover with the front case and begin to fit the JST extension cable inside the enclosure. 

Fit the JST extensions cables socket connector through the notch in the back cover.

Press the front case and back cover together to close them shut.

Install Battery

Connect the battery to the JST extension cable.

Place the battery into the 3D printed tray.

Final Build

Congratulations on your build!

The Feather ESP32-S2 will power on immediately after connecting the battery. Plug in a USB cable to your Feather to begin charging the battery.

Allow the Feather to connect to your WiFi and establish a voltage reading. This may take a minute or two to output to the TFT display.