Quick Connects

Use two pairs of quick connect cables. Remove the JST connectors from the cables. Remove a bit of insulation from each wire and apply solder to tin them.

Connect Wires to Feather

Solder the two blue wires to the ground pin on the Feather.

Solder a white wire to the 3V pin on the Feather.

Solder the second white wire to D5 pin on the Feather.

Arcade Button

Remove the switch and LED assembly from the arcade button by turning it counter-clockwise and pulling it out from the stem.

Unscrew the plastic hex nut from the stem of the button.

Remove the hub panel from the stem.

Connect Wires to LED & Switch

Plug one of the ground wires from the Feather to the ground terminal on the LED.

Plug the 3V wire from the Feather to the anode terminal on the LED.

Plug the D5 wire from the Feather to the NO terminal on the switch.

Plug the remaining ground wire to the COM terminal on the switch.

Connected Feather

Take a moment to ensure the quick connect wires are attached to the correct terminals on the switch and LED.