Install Button

Insert the button into the top cover with the notches lined up.

Place the hub panel onto the stem of the arcade button.

Screw the plastic hex nut onto the stem and tighten.

Install Switch LED

Push the switch/LED assembly into the bottom of the stem and twist clockwise to lock into place. 

Install Case

Fit the two case parts together so the hole for the feathers USB port are lined up. 

Install Top

Place the top cover over the case so the notches are lined up.

Firmly press the top cover into the case.

Install Feather

Place the Feather onto the built-in standoffs on the bottom cover with the USB port facing the edge.

Use two M2.5 x 6mm long steel machine to secure the Feather to the bottom cover.

Install Bottom Cover

Insert the bottom cover into the case with the USB port holes lined up.

Secure Bottom Cover

Line up the mounting holes on the bottom cover with the mounting tabs in the case.

Use four M3 x 6mm long steel machine screws to secure the bottom cover to the case.

USB Power

Connect a USB-C cable into the USB C port on the Feather ESP32 S2.

Connect the USB-C cable to a 5V 1A power supply.

Install Bezel

Snap the matching colored bezel onto the arcade button. Use double-sided tape or glue to adhere the bezel.

Connect Smart Plug

Plug the TP-Link Tapo device into a wall outlet, then plug in lights or other appliance to the outlet 1 (the outlet on the left).

The green light will power on when the outlet is on.

Final Build

Press the button to turn on/off the smart outlet.

Congrats on your build!