Solder four wire connections as follows:

  • motor controller VIN -> Flora 3.3V
  • motor controller GND -> Flora GND
  • motor controller SCL -> Flora SCL
  • motor controller SDA -> Flora SDA

Solder the vibtration motor to the + (red) and - (blue) on the motor controller.

Use a piece of double sided foam tape (or velcro tape) to affix the moto controller to the back of Flora, and plug in your battery.

This guide was first published on Nov 25, 2015. It was last updated on Nov 25, 2015.

This page (Solder Circuit) was last updated on Nov 25, 2015.

Text editor powered by tinymce.