Assuming you have already gone through the WipperSnapper Setup page and connected your board(s) to WipperSnapper, navigate to the WipperSnapper board list. You should see your newly connected FunHouse board listed here.

If you do not see your FunHouse listed - go back to the WipperSnapper Setup Page and make sure its registered with Adafruit.io

On the device page, quickly check that your device is online and is running the latest version of the WipperSnapper firmware.

The device tile on the left indicates the version number of the firmware running on the connected board.

• If the firmware version is green with a checkmark - continue with this guide.
• If the firmware version is red with an "X" - update to the latest WipperSnapper firmware on your board before continuing.

Adding Components

From the FunHouse device page, click the Auto-Config button, which can be used to automatically set up all of the various buttons, LEDs, and sensors built into the FunHouse.

On the pop-up, select Import Config to have Adafruit IO do all of the heavy lifting.

Use this file to add just the components for this project (later try out Magic Config):

Your FunHouse built in components should all be set up and configured, and the the display initializes, showing the WipperSnapper logo followed by the status bar.

You can do a quick test to confirm it is all working as it should by pressing the Down and Up buttons. The corresponding button component should instantly react.

Make sure you press the Down button at least once! You'll use the press event timestamp later.

The next step sets up Adafruit IO Actions to get all of this to work.