Mini TV Build
Who says handhelds need to be handheld? This variant flips the handheld console concept on its head and turns the thing into an integrated console/TV set that you play with a controller. If you bring this on the plane and set it up on your tray table everyone will be jealous of you and you'll probably get a free extra stroopwafle.
Feather Headers
Place two sets of header pins in the Feather. Press them into the TFT FeatherWing for spacing and then solder them to the Feather.
Add Speaker
Solder the mini speaker's red wire to the amp positive (+) and the speaker's black wire to the amp negative (-) pad.
Amp Wires
Prep the five wires for the amp breakout by cutting 4" lengths and trimming some insulation from each end. Tin the wires.
Solder these wires (as shown in the Fritzing diagram):
- Red to 3V
- Black to GND
- Blue to 13
- Gray to 12
- White to 27
Amp Wires II: Auditory Bugaloo
Solder the wires to the amp now:
- Red to Vin
- Black to GND
- Gray to LRC
- White to BCLCK
- Blue to DIN
Wii Nunchuck Adapter
Plug the Wii Nunchuck adapter into the STEMMA QT port on the Feather or FeatherWing with a STEMMA QT cable.
Testing, Testing 1, 2, 3...
This is a terrific time to flip the TFT FeatherWing's ON/OFF switch to the on position to make sure everything's working.
Enable Switch
So you can turn the device on and off once it's enclosed, you'll add a slide switch.
Clip one outer leg from the slide switch. Then, tin the remaining two legs with solder.
Cut two 3" lengths of wire, then strip a bit of insulation from each end and tin the wires.
Solder the two wires to the two switch legs.
Solder the two wires (order doesn't matter) to the GND and En pin on the Feather TFT as shown.
3D Case
Print the files linked below in PLA filament with standard settings. Extra points for translucent PLA because it looks super rad.
Assembly
Place the battery in the case as shown.
Peel the sticker adhesive protection film and place it in the base of the case.
Feed the controller end through the opening and plug it into the Wii Nunchuck Adapter.
Charge
The battery should be good for 8-10 hours of game play. You can charge it by plugging in a USB C power cable.
Page last edited October 05, 2026