An exotic new microphone has arrived in the Adafruit shop, a PDM MEMS Microphone! PDM is the 'third' kind of microphone you can integrate with electronics, apart from analog or I2S. These microphones are very commonly used in products, but are rarely seen in maker...

This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of 2mm, but still have a nice latching feel, while being easy to insert and remove.

The eyes have it! Add this little lens to make a big expression with our Spooky Eyes demo for microcontrollers or Raspberry Pi. These are plastic lenses, with brilliant clarity and a nice convexity (is that a word?) They've even got a lip-edge so you can mount them easily with a 38mm...

Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 420mAh for a total of about 1.55 Wh. If you need a larger (or smaller!) battery,

This basic cable comes with two 3.5mm (1/8" headphone jack size) stereo connectors. It's fairly straight forward, you'll commonly need these to connect two audio devices together.Cable is 6 ft long.

Always be ready rock out or record with this 5-watt Guitar Amplifier, Portable Recorder, and USB Audio Interface from Monoprice.This handheld 5-watt amp delivers plenty of loudness and clarity for ad hoc al fresco performances. It has a built-in guitar...

Add some extra boom to your audio project with these powered loudspeakers. We sampled half a dozen different models to find ones with a good frequency response, so you'll get quality audio output for music playback. Simply connect the standard 3.5mm stereo plug into your Raspberry Pi model...

Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M2.5 size screws fit almost all of the Adafruit breakout/dev board mounting holes...