Enhance a simple rubber hand puppet with MONSTER M4SK eyes and voice changer!
By snapping the MONSTER M4SK in half (safely!) and joining the halves back together with the 9-pin JST SH cable, you can place extra awesome eyes on a rubber hand puppet, such as the dinosaur shown here. And, the PDM microphone and audio output allow us to run voice changer code for extra puppeteering fun!
Peep dis! Have you always wanted to have another pair of eyes on the back of your head? Or outfit your costume with big beautiful orbs? The MONSTER M4SK
guides with product
$44.95
In Stock
An exotic new microphone has arrived in the Adafruit shop, a PDM MEMS Microphone! PDM is the 'third' kind of microphone you can integrate with electronics,...
guides with product
$4.95
In Stock
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
$0.95
In Stock
The eyes have it! Add this little lens to make a big expression with our Spooky Eyes demo for microcontrollers or Raspberry Pi. These are plastic lenses, with brilliant clarity and a...
$3.95
In Stock
You'll want to get two of the lenses
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
$6.95
In Stock
This basic cable comes with two 3.5mm (1/8" headphone jack size) stereo connectors. It's fairly straight forward, you'll commonly need these to connect two audio devices...
$2.95
In Stock
Add some extra boom to your audio project with these powered loudspeakers. We sampled half a dozen different models to find ones with a good frequency response, so you'll get...
$9.95
In Stock
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
guides with product
$16.95
In Stock
Materials & Tools
In addition to the parts above you'll also need:
- Rubber hand puppet, such as this dinosaur
- Diagonal cutters
- Safety glasses/goggles
- Hobby knife
- Awl
- Small scredriver
- Depending on the puppet you use, you may need different hardware fasteners. I used M2.5 x 16mm socket head screws and nuts for the raptor
Text editor powered by tinymce.
