Align Blade parts
Attach each blade part with M2x8mm screws.
Use a Pivoting Bit Tip Holder and a Philips bit to easily secure parts.
Solder LED strip
Measure wires 130mm long to connect the LED strip to the Feather.
Place LED strip
Arrange the LED strip between the stand-offs and the wall of the blade.
Connect blade halves
Use M2x8mm screws to secure both halves of the blades together.
Thread wires
Pass the LED strip wires through the handle-top part.
Use M2x8mm screws to connect the blade to the handle-top part.
Repeat this process for the second Blade Assembly 🗡️
Connector Tabs
Align the connector tabs to the handle parts. Use M2.5x8mm long screws to the secure the tabs to the handle parts.
Slide Switch and speaker wires
Solder wires to the slide switch and connect to the EN and GND pins on the Feather board.
Speaker Holder
The oval speaker press-fits into the speaker holder part. Use M2.5x6mm screws to fasten the speaker holder to the stand-offs in the handle.
Mount Feather and Lipo
Use M2.5x6mm screws to secure the Feather to the stand-offs.
The slide switch press-fits onto the cut outs on the handle part.
Use a loop of gaffers tape to add a cushion to the lipo battery. Place under the Feather board and connect to the JST port.
Align Blade wires
Place blade assemblies close to the handle assembly.
Connect LED strip wires
Connect each wire to the terminal block on the Feather board.
Attach Handles
Place the two handle halves together and press-fit to join.
Connect Blades
Press-fit the handle-top parts to the handle and secure with M2.5x8mm screws.
Secure Handles
Use one more M2.5x8mm screw on the middle portion of the handle to join the two parts together.
Page last edited May 14, 2024
Text editor powered by tinymce.