PCB Mount Screws

The PCB mount needs the following hardware for installing.

  • 4 x M2.5 x 8mm female to female standoffs
  • 4x M2.5 x 4mm screws

Installing Standoffs

Insert the nylon screw through one of the mounting holes through the top. Hold in place and install standoff by fastening onto screw thread.

Installed Standoffs

Tightly fasten the remaining screws and standoffs.

PCB Mount

The hole in the center of the mount can be used for passing wires and cabling through to connect to the HalloWing M4.

This guide was first published on Oct 14, 2019. It was last updated on Oct 14, 2019.

This page (PCB Mount) was last updated on Oct 11, 2019.

Text editor powered by tinymce.