Jump scares are fun, but how about a jump scare that is fully automated? Even better! This one uses the HalloWing with a PIR motion sensor, servo motor, and speaker to detect victims and drop a creepy rubber bug right in front of them as it hisses terrifyingly!

You can plug these parts right into your HalloWing, code it in CircuitPython, and get to scaring people in no time.

Parts

1 x Adafruit HalloWing M0 Express

Skull-shaped ATSAMD21 board w 1.44" 128x128 TFT display

1 x PIR (motion) sensor

Passive Infrared detector

1 x Micro Servo

Tiny 180 degree rotation servo

1 x JST PH 3-Pin to Female Socket Cable

200mm

1 x JST PH 3-Pin to Male Socket Cable

200mm

1 x 5V 2.5A Switching power supply

with 20AWG MicroUSB Cable

Materials

In addition to the above parts, you'll need the following:

Thin thread or mono-filament fishing line
Creepy rubber bug
Double stick foam tape
Cardstock
Cardboard or corrugated plastic for mounting
Gaffer's tape

This guide was first published on Sep 29, 2018. It was last updated on Sep 29, 2018.

This page (Overview) was last updated on May 05, 2021.

Text editor powered by tinymce.

Search