Hardware for Perma Proto

Use the following hardware to secure the Perma Proto to the bottom cover.

• 4x M3 x 10mm screws
• 4x M3 hex nuts

Install Screws and Nuts

Insert the M3 screws through the bottom mounting holes. 

Place the Perma Proto board onto the standoffs with the thread of the screws going through the mounting holes.

Use the hex nuts to secure the Perma Proto board to the bottom cover.

Secured Perma Proto

Inspect the Perma Proto board and 4-pin cable to enclosure none of the wires are being kinked.

Install Frame

Orient the case frame with the bottom cover.

Snap fit the case frame over the bottom cover. 

Connect Cables

Plug in a USB-C cable to the QT Py.

Install Top Cover

Orient the top cover with the case framing and snap fit them together.

Final Build

Plug in the USB-C cable from the QT Py to a 5V power source.

Congratulations on building the neon sign!

Additional Signs

Repeat the processes above to create the other signs.