Wiring LEDs

There are six LEDs used in this project, each needs two wires – That's a total of 12 wires. Each LED needs a 220ohm or 330ohm current limiting resistor. We'll connected all of the wires into a quarter size Perma-Proto breadboard PCB. To power the LEDs, we'll connect a switched JST breakout board to the perma-proto. A 3.7V Lithium ion polymer battery will supply the voltage.

This provides a visual reference for the wiring of the components. They aren't true to scale, just meant to be used as reference.

This guide was first published on Jun 14, 2017. It was last updated on Jun 14, 2017.

This page (Circuit Diagram) was last updated on Jun 14, 2017.

Text editor powered by tinymce.