LED Noodle Wiring

Make two wires that are 7.5 inches (19cm) in length, preferably in red and black colors.

Trim the leads from the 100 Ohm resistor so they're short.

Solder the black wire to the resistor, then solder the resistor to the cathode pin on the LED Noodle (no hole end).

Solder the red wire to the LED's anode pin (the one with the hole). 

Wired LED Noodle

Take a moment to ensure the wires and resistor has been properly soldered to the LED noodle.

Wiring Button

Make two wires that are 8 inches (20cm) in length, preferably in white and black colored wires.

Solder the white wire to either of the two leads on the button.

Solder the black wire to the remaining lead on the button.

Wired Button

Take a moment to ensure the wires have been properly wired to the leads of the button.

Slide Switch Wiring

Create two wires that are 2.5 inches (6cm) in length. These can both be in black.

Snip off one of the leads on the slide switch, either the far left or right but not the middle. Then, trim the two remaining leads short, about half their length.

Solder the two wires to each of the leads on the slide switch.

Wire Switch to Feather

Solder the two wires from the slide to the EN and GND pins on the bottom of the Feather.

Wired Slide Switch & Feather

Take a moment to ensure the wires from the slide switch has been properly soldered to the pins on the bottom of the Feather.

Speaker Wiring

Cut off the connector from the speaker. Using wire stripper, remove a bit of insulation from each wire.

Tin the exposed wires by adding a bit of solder.

Speaker

Take a moment to ensure the wires have been tinned.