Assemble

Ruiz Brothers
3d_printing_slip-on.jpg

Adding tripod thread


Push the tripod thread with the wide part on the outisde.

Tighten the thread with a flat head screw driver or screw on a tripod to fasten the threads tight.

Slightly tug on the thread to make sure it has a good grip inside the mount.

Make sure the thread is flush with the underside of the case.
3d_printing_hero_back.jpg

Align ports


Make sure all of the ports are aligned by rotating the case around the camera body. The USB/HDMI port should open by slight moving the thin part of the frame while pushing the latch open.

3D PRINTING
This guide was first published on Dec 28, 2016. It was last updated on Dec 28, 2016.
This page (Assemble) was last updated on Apr 04, 2019.