Download the 3D printing files using the button below!

Download and print out both the "glowy-crown" and the "glowy-crown-cover" files. The cover simply press fits onto the back of the glowy crown to secure the electronics. 

You may want to use a brim when printing out the crown to improve adhesion since the sides are a bit thin. There should be no supports needed for either of these. 

The design is parameterized, and the step file is included here so you can customize the number of holes in case you want your message to be different. An odd number of holes will work best -- you can add an exclamation point or a space to your message to make it so!

Note: The photos in this project use a silver switch with different dimensions from this Adafruit switch. If you're using the Adafruit switch, use the file named glowy-crown-adafruit-switch. You can also change the parameters in the .step file included to fit your specific switch. Both .3mf and .stl files are included.

This guide was first published on Nov 10, 2021. It was last updated on 2021-11-10 13:47:15 -0500.

This page (3D Printing) was last updated on Nov 27, 2021.

Text editor powered by tinymce.