3D Printed Stand

This simple stand is designed for the Adafruit FunHouse. It features a nice brick texture that is reminiscent to the Yellow Brick Road from The Wizard Of Oz.

The stand features four M3 size mounting holes for securing the Adafruit FunHouse. It is optimized to 3D print without any support material.

Prerequisite Guides

Take a moment to walk through the following guides:


Top-down video of Adafruit Funhouse PCB. The TFT display shows a data readout, and the NeoPixel LEDs glow rainbow colors.
Home is where the heart is...it's also where we keep all our electronic bits. So why not wire it up with sensors and actuators to turn our house into an electronic wonderland....
In Stock
Opened box showing many nylon screws
Totaling 420 pieces, this M3 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel...
Out of Stock
USB Type C Cable with Data/Charge Switch
Perhaps your smart phone, tablet, or even your Raspberry Pi 4, charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow...
In Stock
1 x Ultra Silk Gold PLA
1.75mm diameter filament by Eryone

This guide was first published on May 11, 2021. It was last updated on Mar 08, 2024.

This page (Overview) was last updated on Mar 08, 2024.

Text editor powered by tinymce.