Attach the 3D printed stand-offs to the perma-proto board with M2.5 screws. The stand-offs have an edge that lines up with the side of the perma-proto.

Insert the two 2x8 plug headers into the 2x16 socket header on the Fruit Jam.

Plug the socket header on the perma-proto onto the plug headers in the Fruit Jam. The 3D printed stand-offs will align with the bottom mounting holes on the Fruit Jam.

Plug the JST-PH potentiometer cable into the A0 port on the Fruit Jam.

Insert the Fruit Jam into the 3D printed case. Secure it with three M3 screws.

Attach M2.5 stand-offs to the PDM microphone.

Secure the PDM microphone in the enclosure with two M2.5 screws.

Attach the potentiometer to the case lid with its included nut.

Attach the lid to the case with four M3 screws.

Secure the knurled knob to the potentiometer.

That completes the assembly!