Install Fruit Jam

Begin by orienting the board with the bottom half of the case. Then, place the PCB onto the part with the mounting holes lined up.

Ensure the PCB is fully seated onto the standoffs.

Install On/Off Actuator

Insert the on/off switch to the matching hole in the top cover. It should have a snug fit.

Take note of the position of the switch, and make sure the on/off switch on the Fruit Jam is matching before fitting the top over the bottom half of the enclosure.

Connect Speaker (Optional)

If you'd like to include the mini oval speaker, you can adhere it to the top cover. We've tested the best place to stick it is next to the LED guard. Take note of the speaker cable's orientation.

To connect the speaker to the Fruit Jam, plug in the connector to the speaker port on the Fruit Jam (it might still have the protective cover install, if so, simply remove it).

Snap Close

Orient the top cover with the bottom half of the enclosure. Before closing the case move the on/off slide switch actuator to the same side as the on-board switch.

Firmly press the two halves together to snap fit them closed.

Switch It On/Off

The 3D printed switch piece should fit over the actuator of the switch on the Fruit Jam. Small nubs built into the piece will prevent the actuator from falling out of the enclosure.

Test the switch by sliding it from side to side. 

All Done!

With the case fully assembly, take a moment check the two halves are fully seated.