Next we'll attach the two 100-ohm resistors. Twist one set of their legs together as shown. Resistors don't have polarity, so it doesn't matter which way they are facing.
Slide a short piece of heat shrink tubing around the twisted resistor legs, leaving a small section of wire exposed at the end.
Insert the short wire end into the hole marked VBATT (battery voltage +) and solder in place. Clip any excess wire on the other side of the Flora. |
|
Bend the resistor legs to follow the curve of the Flora board, as shown. |
|
Add heat shrink tubing to the resistor leads. Next we'll install the IR LEDs between the transistors and resistors! |